Toolman I wish I knew where all of the later model Ford vans end up.I have this vision of finding an 08 up window van with RSC for the rear axle and a bunch of little interior parts. Through the years I used to have a bunch of 1971-1995 GM vans and there are tons of them in the pick and pulls around here but almost no Fords except mid 90s plumber vans that really are junk and not many parts left. I am looking at/for seats this week so if I see one like your I will let you know.
You might try one of these guys and if you have any places that specialize in vans near you you might try them. Here in California if they are using the van as a bus (for a church or small school they have to take out the passengers side front seat so sometimes they have almost new ones.
Any Kar Seats 150 West Lennon Street Gardena,CA 90248 Call 800-220-8292 or 310-323-7664
Bill, Van Seats
cmagnetics@yahoo.com 408-329-2644
In addition How is your van going? Someday I will get going on my U-joint install I swear.
DI can't remember did you do a Sterling swap or is your van a full floater Dana 60?
Also can you still get a Snap-On CTB100 9.6 Battery Pack? My old 3/8 impact battery has failed from lack of use and old age since I am not turning wrenches for the past 10 years except at home.
Thanks...Jamie