SOLD --- Truck Fridge TF49 12-volt DC 49 liter refrigerator

[TroySmith80]

SOLD


Truck Fridge TF49 12-volt DC 49 liter refrigerator

See http://www.truckfridge.com/tf49.html or http://www.bigriggifts.com/cgi-bin/a...s=tf49&x=0&y=0

This fridge uses the famous Danfoss compressor so it is very quiet and efficient. Its average power consumption over the course of an hour is 24 watts. It has a freezer compartment, ice tray, inside light, shelves, etc.

This is like new. Never installed, never used. I bought it for a camper van project that never came together. I bought the fridge in December and have since bagged the project. When i received the fridge i took it out of the box and ran it for several hours to confirm that everything works as it should. I then put it back in it's original packaging to wait for installation... and there it has remained.

These go for $500+shipping. This is absolutely like new! I'll sell for $400+Shipping. Save $100, give nothing up. It's only a quarter of the way through its 2-year warranty! I'm located in Bend, Oregon.

Model TF49
Size - H x W x D 20 ½" h x 15" w x 18" d
Gross Capacity 49 litre/1,73 cu. ft.
Nominal voltage 12-24 Volt
Nominal imput 60 Watt
Refrigerant R 134 a
Internal Light Yes
EMC conformity Yes
Air-cooling Forced with fan
Average consumption 24 watts/hour
Net Weight 35 lbs.

[TroySmith80]

If you like the fridge but my price isn't right, make an offer. I'm not sure exactly what's fair, but it doesn't seem that i should need to discount a lot since it is basically brand new and has lots of warranty remaining.

[Gooseberry]

Need to check measurements tonight and might be interested. This is a dc only unit or does it have the 110/ 12 option


Sent from my iPhone using Tapatalk

[TroySmith80]

DC only, but it doesn't pull that much current, so you wouldn't need much of an inverter to run it from AC.

[Gooseberry]

To small to fit my opening.

[TroySmith80]

The fridge is too small, or the opening is too small? If the fridge is too small, that's no problem, just pop in some supports and a little bit of trim board around the front if desired. If the opening is to small, that could be a little harder to address.