If you have an older two arm swingarm (Galley/Generator box), can you upgrade to a newer three arm box (Deluxe box)?
Or, do you just swap the box itself, and leave the arm structure alone? My concern is that a bigger box means more stuff which means more weight, and that starts to concern me with the two arm support structure.
Herb
__________________
SMB-less as of 02/04/2012. Our savings account is richer, but our adventures are poorer.
That's a valid issue Herb and Aluminess suggested not to overload it. I had 4 hinges put on, but if you figure your only going to carry the weight of 4 jerry cans full of fuel or water, it should be OK. I would suggest purchasing the kit they sell to upgrade the hinge bolts plus the bumper blocks they install if they sell those. Or do it yourself like Mike did.
Dave
__________________
2006 Ford 6.0PSD EB-50/E-PH SMB 4X4 Rock Crawler Trailer
Aluminess boxes not eligible for the vendor promo. Apparently too little of a margin.
Bummer.
Yeah, I just reread that:
"This offer applies on the purchase of bumpers, roof racks, tire racks, ladders and nerf bars, and is not good with other offers."
Boxes not mentioned. Too bad, I didn't realize they were excluded.
Still cheaper to have the ship the box to Colorado rather than drive down to San Diego and pay the CA sales tax. I think I'll beef up the latches and add the stops while I'm at it.
__________________
Back to a Build Sheet and a Dream...