The sensor from my 03 sf axle slipped right into the 05 ff fseries axle I installed and didn’t trigger any cel’s. so apparently the tone ring matches up as well.
__________________
"understeer is when you hit the wall with the front of your car, oversteer is when you hit the wall with the rear of your car, horsepower is how hard your car hits the wall, and torque is how far your car moves the wall."
The sensor from my 03 sf axle slipped right into the 05 ff fseries axle I installed and didn’t trigger any cel’s. so apparently the tone ring matches up as well.
Right on! Very cool. Does your axle have the single rear sensor (differential mounted) or the dual outboard sensors?
I might have mis-quoted the years by a year or two.
__________________
Mike T
___________________
'95 Ford E250 RB30 PH
__________________
"understeer is when you hit the wall with the front of your car, oversteer is when you hit the wall with the rear of your car, horsepower is how hard your car hits the wall, and torque is how far your car moves the wall."
4-channel ABS (outboard rear speed sensors) started in 2005 on RSC models and went to all Econolines for 2008.
The 2005-2008 RSC axles are full floats, however adding a center sensor to an RSC axle would require a good machinist with big equipment. Being close isn't good enough for speed sensors.
^^^ not bad at all! that's a pretty nice shaped top too. whats the front look like?
our local pick and pulls charge $180 for a tv top off a typical conversion van, but you rarely see eb conversion vans.
__________________
"understeer is when you hit the wall with the front of your car, oversteer is when you hit the wall with the rear of your car, horsepower is how hard your car hits the wall, and torque is how far your car moves the wall."
watchtower, white whale, land yacht, big pig...
Thirsty
Linear Mode
