Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 


Reply
 
Thread Tools Display Modes
 
Old 05-02-2008, 02:09 PM   #1
Senior Member
 
Jeffrey's Avatar
 
Join Date: Apr 2007
Location: Santa Barbara, CA
Posts: 1,841
Garage
Adjusting the PH springs

My PH is a lot to lift (manually). The springs don't seem to be set right to make it easy. I can't put anything on the roof, like a bike, or I can't lift it. The springs are supposed to be balanced and do the lifting once you start the lift. Has anyone here adjusted theirs? I'd hate to drive to Fresno just for this.

__________________
'07 RB-50 - My Photo Site -- K1JGS --
Jeffrey is offline   Reply With Quote
Old 05-02-2008, 09:25 PM   #2
Senior Member
 
PeasBugs's Avatar
 
Join Date: Apr 2007
Location: Soquel, CA
Posts: 154
I'm sorry I can't help very much, but it seems that it should be set up to be able to lift the top + 50 to 100 lbs. I have the electric top and I have not heard of adjustment of the springs.
__________________
2007 Sportsmobile EB-50 4X4 6.0 Diesel with extras
PeasBugs is offline   Reply With Quote
Old 05-02-2008, 09:43 PM   #3
Senior Member
 
Greg In Austin's Avatar
 
Join Date: Jul 2007
Location: Austin, Texas
Posts: 1,543
Send a message via AIM to Greg In Austin Send a message via Yahoo to Greg In Austin
There is a website that shows how to adjust the springs, but it is also dangerous and says so.....

,... if the owner is out there they might be able to post the site....

I will check and see if I have it somewhere in my archives...


.
__________________
Greg in Austin
2008 Ford 6.0PSD EB/E-PH SMB 4X4 Aluminess f/r bumpers (13.5mpg avg, 15mpg hwy) 52k miles [Texas McBeast]
2006 Toyota Prius (48 to 68 mpg) 120k miles [Penelope]
2013 Jeep Wrangler Unlimited Rubicon (15 to 18 mpg) [Johnnie]
2012 Mitsubishi MiEV (no gas required) ($.50/day in electricity) [Evie]
https://badge.facebook.com/badge/1232...3.32047100.png
Greg In Austin is offline   Reply With Quote
Old 05-03-2008, 06:00 AM   #4
Senior Member
 
Greg In Austin's Avatar
 
Join Date: Jul 2007
Location: Austin, Texas
Posts: 1,543
Send a message via AIM to Greg In Austin Send a message via Yahoo to Greg In Austin
OK... I found it..... but recognize it says it is dangerous and not endorsed by SMB..... or by me!

http://www.fx4.net/smb_mods/tension/index.html

...but it looks like it would work...


.
__________________
Greg in Austin
2008 Ford 6.0PSD EB/E-PH SMB 4X4 Aluminess f/r bumpers (13.5mpg avg, 15mpg hwy) 52k miles [Texas McBeast]
2006 Toyota Prius (48 to 68 mpg) 120k miles [Penelope]
2013 Jeep Wrangler Unlimited Rubicon (15 to 18 mpg) [Johnnie]
2012 Mitsubishi MiEV (no gas required) ($.50/day in electricity) [Evie]
https://badge.facebook.com/badge/1232...3.32047100.png
Greg In Austin is offline   Reply With Quote
Old 05-03-2008, 10:00 AM   #5
Senior Member
 
Jeffrey's Avatar
 
Join Date: Apr 2007
Location: Santa Barbara, CA
Posts: 1,841
Garage
Thanks Gregg. I'll read it and take caution.
----------

OK, I looked at what was shown and must say I've never seen a more useless and poorly described procedure. It doesn't seem to be complete, and there is no reference at all to what they are trying to accomplish or how to make the actual adjustment.

Time to call Fresno!
__________________
'07 RB-50 - My Photo Site -- K1JGS --
Jeffrey is offline   Reply With Quote
Old 05-03-2008, 10:10 AM   #6
Senior Member
 
Ford_6L_E350's Avatar
 
Join Date: May 2007
Location: Washington - Ridgefield
Posts: 4,728
I adjusted the PH springs on my SMB. It really isn't that difficult. The above mentioned website shows how it is done.

The only things to remember are:

- Brace the top. Both so it doesn't come down and so it doesn't load the springs.

- Pull the chain to stretch the spring and attach it to a different link. My comealong fit into a link of the chain, no added parts needed.

I had added a solar panel (~ 35#) to the roof and it became very difficult to lift. It took two links on the chain to get it where I wanted it to be. Of course, it took three tries to settle on two links.

Mike
__________________
Alaska to Key West, Labrador and more
Prostate cancer survivor. See Thread Prostate cancer and Sportsmobiles
2015 VW GTI 2020 Fiat 124 Spider
2012 E250 Hitop camper
Ford_6L_E350 is offline   Reply With Quote
Old 05-03-2008, 01:39 PM   #7
Senior Member
 
yvrr's Avatar
 
Join Date: Oct 2007
Location: Newark, CA
Posts: 795
It depends on whether you are compensating for a permanent load or a log which isn't on top all of the time. You can adjust the springs to allow 50-100 lbs on top but then, when that load isn't there, you will have a hard time getting the top down. Also, the manual penthouse works best with nothing on it. We added three of the older solar panels a couple of years ago which might weigh 75 lbs. total and SMB adjusted the springs when they installed the panels. It, while I can get it up, it takes quite a bit of strength to get the penthouse up to the "neutral" point...it is easier after that point but it was much easier before the panels were added.

We have a 55 lbs kayak that we sometimes carry. We purchased one of the SMB "portable" electric lifts to be able to lift the penthouse while the kayak is on top. If your load changes all of the time, that would be a better solution.
__________________
Jack
'01 Ford EB50p Quigley 4WD
yvrr is offline   Reply With Quote
Old 05-03-2008, 02:39 PM   #8
Member
 
LoneStarJR's Avatar
 
Join Date: Sep 2007
Location: Austin, TX
Posts: 59
Is it possible to insert a turnbuckle between the spring & the chain to make adjustment for varying roof loads easier?
__________________
2008 CHEVY 6.6L DURAMAX / QUIGLEY 4X4 / RB50
LoneStarJR is offline   Reply With Quote
Old 05-03-2008, 04:48 PM   #9
Senior Member
 
Jeffrey's Avatar
 
Join Date: Apr 2007
Location: Santa Barbara, CA
Posts: 1,841
Garage
SMB portable electric lift? Whazzzat?
__________________
'07 RB-50 - My Photo Site -- K1JGS --
Jeffrey is offline   Reply With Quote
Old 05-03-2008, 06:17 PM   #10
Senior Member
 
jage's Avatar
 
Join Date: Apr 2007
Location: Parker, CO
Posts: 7,643
Quote:
Originally Posted by LoneStarJR
Is it possible to insert a turnbuckle between the spring & the chain to make adjustment for varying roof loads easier?
Unless you found some way to take the tension off the turnbuckle you would have a heck of a time tightening or loosening it. I'm assuming from the use of the come-along that there is no small amount of tension involved.
__________________
it was good to be back
jage is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Sportsmobile SIP or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 04:02 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.