Front bumper info

[K31 Van]

Awesome guys thank you. I also called weldtec design vans here in San Diego and they were very cool and helpful. With the same story. I am hood with that because i what it out front a bit more. Now looking for a black or non chrome one. Thanks again.

[MountainBikeRoamer]

Hey K31 Van, that's great news.

Now just be sure you do the right thing:
Once you get a bumper and get it mounted........
.........BE SURE TO POST SOME PICTURES!!!

Originally Posted by K31 Van

Awesome guys thank you. I also called weldtec design vans here in San Diego and they were very cool and helpful. With the same story. I am hood with that because i what it out front a bit more. Now looking for a black or non chrome one. Thanks again.

[K31 Van]

08 mounted up ez no mods going to build valance to fill gap

[Bellpilot]

2008 will not fit but up to 2007 will.

[K31 Van]

Took about 45 min to pull 2000 and bolt 2008 in its place neefs filler on top bumper to gr
ill

[cfh420]

I installed one just to see if it fit and If I remember correctly it's stuck out a little too far from the front and looked funny.
I also did the opposit. I installed an iron cross bumper for a 2007 on to a 2010. I had to make spacers to push that bumper forward. That picture maybe on my website I don't Remember.
Swc4x4.com
If it isn't email or message me I'll send you a pic

[K31 Van]

It sticks out about 7 or 8 inches, but that what i wanted the wheel well line meet up good. I want to tuck a winch behind it and keep a reasonable stock look

[Vanimal]

Looks good.
I wanted to go the other route and swap the grille and fenders to try and fit an intercooler! I will have to remod my winch bumper though.

[K31 Van]

all installed time to take it all apart and send to powercoat

[Lenny]

I wish I had thought of using an 08 bumper when I did my winch/stock bumper install.
The stock bumper left me only a few inches between the rear of the winch and the radiator.
Nice job bud, looks good.