Originally Posted by winnievan
Ray -- stay safe out there -- can you provide a bit more information on how the seat belt pretensioner circuit is handled with these bases? Does it require anything more than simply removing it and passing it thorugh the swivel and then reconnecting it?
That's correct. Unplug the connecter, swap bases, plug connector back in. The one thing to be careful of is maintaining enough slack during rotation (always rotate towards the middle of the van). This can require popping up a hold-down clip or two so that harness can leave the floor a little more aft than it does with the stock base. There'ss quite a bit of variation from year to year, so if you have concerns when you do the install, just post a pic, and you'll get some help.