Stephane- you are good!
Just in case anyone wonders about shipping, this is typical Group Buy shipping day! 85 degrees. Awning out, music and a beer kept cold by the sun!!! In this case, moving 700 lbs of Bases about six times from pick up to drop off at FedEx. This was a light batch!!
From passenger rear- after removing stock seat base and before installing the swivel base - extract the seat sensor wire back to the harness running behind the seats. Cut an X in the carpet/mat at the rear edge of the swivel base floor plate. Run the seat sensor wire up through the X, then inboard of the swivel drum to the front. Disassemble the connector coming from the seat (mark which ports each of the wires are in), pass the wires down through the smallholder in the upper plate of the swivel base. Reassemble connector. Reconnect connector. Small split loom is great for protecting the wires. Do this and no cutting or extending of wires is need for either driver or passenger. Ping me with any questions!! Thxs ��