So where the heck do you jack up the front of the quigley e350? Rear is obvious. Front not so much.
I've got either a floor jack or agile's adapter for the scissor jack from the hummer to lift the van with. No place on the front axle to lift with. due to the non centered pumpkin on teh diff.
Why not the axle? When I added new coil springs to mine I took the front bumper off and used the hi lift in the frame but just for changing a tire or something seemed like the axle worked fine.
__________________
2015 Chevy Express 3500 Duramax
w/ Quigley 4x4 & Agile Fox shocks
Sold 2005 E350 Chateau
Quigley with Agile RIP, 6.0 PSD
I'm most concerned about the jacking point on the front left of the vehicle. I was able to jack the right front side no problem.
Can't seem to find a suitable spot to jack from. The pumpkin is on the left side so axle is not an option. I think the manual says where the radius arm meets the axle?
Ok to jack at the radius arm?
Quote:
Originally Posted by 1der
Sounds like you are wanting to lift both tires at the same time? Is the concern lifting on the center of the tube part of the axle?
I lift one side at a time and use jack stands, or if changing one tire, I lift off the end axle towards the tire I want to change.