Quote:
Originally Posted by Wisco150
Thank you. The wires going to the cats were also cut. Does anyone know if that’s part of the entire wire harness requiring new wires to be spliced or if it’s a separate smaller segment allowing just that small segment be replaced without the need for splicing?
I attached a picture to try and show one of the wires. This may not be helpful but just tying to figure out more information.
|
I think they cut the wires for the sensor only as the blue plug visible through the hole should be the harness connector.
The catalytic converter you need for that van would be a Magnaflow 4451300 to be legal in CA (really the only one that works in general). Also note, this is the only converter that will allow you to pass the BAR in CA if that's something you need to suffer through.
Ive been through this whole process more than once and it's no fun.
Scott