It’s starting. This will be a slow process so don’t expect too much of me, but I just picked up the top and will remove the shell to redo the raptor liner in black and replace the hardware with new T bolts. I also intend to line the crossbars with chromoly pipe and use shoulder bolts as boywonder suggests.
Any tips on templating the cutout would be greatly appreciated.
I’ll be shortening the side rails as AndrewST did in his thread and will then either make a fairing or add fiberglass to the front of the shell to make a snug fit on the roof line.
Thanks and I’ll try to keep up with posts as I go along. Just need to figure out the cutout sooner than later.