Forum: Projects, Modifications and Known Issues
06-27-2019, 11:53 AM
|
Replies: 318
Views: 73,410
Door Talon
Ray,
I am finally getting around to ordering a door talon. I got swivel base seats for my van last year which work great. My ride is a 2008 E250 Quigley with Bushwacker flares.
Thanks.
|
Forum: Electrical and Electronics
09-06-2018, 07:48 AM
|
Replies: 3
Views: 754
|
Forum: Electrical and Electronics
09-05-2018, 11:32 AM
|
Replies: 3
Views: 754
Looking for 2008 E250 aux battery fuse
I have been busy converting my 2008 Quigley E250, 5.4 gasser to a camper/beach surf fishing buggy. In its earlier life, the van might have been equipped with a wheel chair lift using the second...
|
Forum: Hobbyist Vendor Products
07-30-2018, 02:01 PM
|
Replies: 224
Views: 41,693
Hi Ray.
I bought a passenger swivel in group...
Hi Ray.
I bought a passenger swivel in group buy #7 and would like a driver's side next. I do have a question though. Will the driver's seat be able to swivel with the Quigley 4 wheel drive shift...
|
Forum: Homemade SMB - Ground Up Builds
07-19-2018, 01:10 PM
|
Replies: 11
Views: 2,731
Now the 'after" photos
Got a few pictures of the rust bucket turned beach buggy after liberal coatings of Corroseal and 3M undercoating. Fighting rust on OBX surf fishing vehicles is a constant battle. At least I've slowed...
|
Forum: Homemade SMB - Ground Up Builds
07-18-2018, 07:30 AM
|
Replies: 11
Views: 2,731
Well, Raleigh had heavy rain showers last night...
Well, Raleigh had heavy rain showers last night which put the "after" photos on hold. I am happy to report that the Maxxair roof vent/fan didn't leak a bit. I can't wait to get this buggy out on the...
|
Forum: Homemade SMB - Ground Up Builds
07-17-2018, 12:48 PM
|
Replies: 11
Views: 2,731
Here are a few "before" photos. I'll take some...
Here are a few "before" photos. I'll take some "after" pictures tonight. The worst spots were in the driver and passenger side wheel wells where the #2 mounts attach. I have ground away all the bad...
|
Forum: Homemade SMB - Ground Up Builds
07-17-2018, 07:27 AM
|
Replies: 11
Views: 2,731
Installing Nerf Bars - two man job minus a man
More photos showing the set up I used to install the Aluminess Nerf bars. The trick was to get the bars up to their final attachment position without a second person holding up one end. That floor...
|
Forum: Homemade SMB - Ground Up Builds
07-11-2018, 07:07 AM
|
Replies: 11
Views: 2,731
My Beach Buggy exterior unvail
Hi Folks,
I have spent hours in your forums and have learned a ton. I bought this van off of ebay in November and have spent the last six months going through it. It came from Michigan and of course...
|
Forum: Hobbyist Vendor Products
07-09-2018, 08:12 AM
|
Replies: 224
Views: 41,693
|
Forum: Homemade SMB - Ground Up Builds
06-06-2018, 01:47 PM
|
Replies: 9
Views: 2,063
|
Forum: General Sportsmobile
05-21-2018, 08:18 AM
|
Replies: 10
Views: 2,340
Wow! I am in the process of transforming a...
Wow! I am in the process of transforming a Quigley 250 to a camper. It sounds like a hidden ignition switch should be highly recommended. Any suggestions on the best method/location to do this would...
|
Forum: Engines and Drivetrain
04-16-2018, 10:59 AM
|
Replies: 40
Views: 11,487
|
Forum: Engines and Drivetrain
04-16-2018, 06:09 AM
|
Replies: 40
Views: 11,487
BFH and PBB - 2, stuck rotors - 0. Finally got...
BFH and PBB - 2, stuck rotors - 0. Finally got the rotors off. It was a good weekend. I have removed all of the steering gear and am in the process of putting new new tie rod ends on. Having a bit of...
|
Forum: Engines and Drivetrain
04-13-2018, 12:46 PM
|
Replies: 40
Views: 11,487
|
Forum: Engines and Drivetrain
04-13-2018, 11:18 AM
|
Replies: 40
Views: 11,487
|
Forum: Engines and Drivetrain
04-13-2018, 10:00 AM
|
Replies: 40
Views: 11,487
|
Forum: Van Body
04-12-2018, 09:39 AM
|
Replies: 16
Views: 3,059
|
Forum: Engines and Drivetrain
04-12-2018, 05:52 AM
|
Replies: 40
Views: 11,487
|
Forum: Engines and Drivetrain
04-11-2018, 12:46 PM
|
Replies: 40
Views: 11,487
|
Forum: Engines and Drivetrain
04-11-2018, 11:15 AM
|
Replies: 40
Views: 11,487
Well, I can tell that another viewer of this...
Well, I can tell that another viewer of this thread is from North Carolina. I just found two posts on Craig,s List Raleigh for the Z23 PowerStop rotors and I haven't put mine up there yet.
|
Forum: Show & Tell
04-11-2018, 09:05 AM
|
Replies: 6
Views: 1,332
|
Forum: Engines and Drivetrain
04-11-2018, 06:27 AM
|
Replies: 40
Views: 11,487
I think it is too late for me to replace the...
I think it is too late for me to replace the slotted rotors on the rear. The spacers were an absolute bear to remove. Since my van is definitely going to see lots of beach driving, I ordered...
|
Forum: Engines and Drivetrain
04-10-2018, 01:41 PM
|
Replies: 40
Views: 11,487
|
Forum: Engines and Drivetrain
04-09-2018, 11:15 AM
|
Replies: 40
Views: 11,487
|