Forum: Projects, Modifications and Known Issues
03-27-2022, 04:26 PM
|
Replies: 3,418
Views: 733,011
Just a few van related 3D printer projects. ...
Just a few van related 3D printer projects. First is a wire guide for camera wire hijacking the door wiring passthrough without interfering too much with the rubber sleeve. The material is PETG...
|
Forum: Projects, Modifications and Known Issues
03-30-2016, 08:12 PM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
01-21-2016, 08:21 PM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
01-01-2016, 09:24 PM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
01-01-2016, 09:21 PM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
03-24-2015, 07:14 PM
|
Replies: 3,418
Views: 733,011
Re: What did you do to your SMB today?
With the battery project finished I finally cleaned out the van and test installed the car-seats, which makes the van the go-to kid hauler while the Volvo is in the shop.
Rear facing on the bench...
|
Forum: Projects, Modifications and Known Issues
03-22-2015, 07:12 PM
|
Replies: 3,418
Views: 733,011
Re: What did you do to your SMB today?
Today I finished the project I started yesterday, which was to finish the project I started December 13, 2014.
More here: viewtopic.php?f=14&t=15009...
|
Forum: Projects, Modifications and Known Issues
12-14-2014, 07:24 PM
|
Replies: 3,418
Views: 733,011
Re: What did you do to your SMB today?
Technically yesterday, but I dropped the house batteries and removed them. Took about 3 hours, not the least of which was cutting off the massive wads of self-sealing tape I'd put all over the...
|
Forum: Projects, Modifications and Known Issues
04-05-2014, 05:44 PM
|
Replies: 3,418
Views: 733,011
Re: What did you do to your SMB today?
Not today technically but I finally managed to get my SMB to the emissions place, and after she passed with flying colors had the starter batteries replaced and the oil changed. The really amazing...
|
Forum: Projects, Modifications and Known Issues
10-15-2013, 05:39 PM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
06-17-2013, 07:03 PM
|
Replies: 3,418
Views: 733,011
Re: What did you do to your SMB today?
I figured out my Scangauge II with the X-Gauge will actually reset the check engine light. I'd been trying to on the road with no luck. It went something like:
Van start- get code registered...
|
Forum: Projects, Modifications and Known Issues
04-18-2013, 06:06 PM
|
Replies: 3,418
Views: 733,011
Re: What did you do to your SMB today?
Tie them into the brake lights, they're right there, stop turn, everything you need.
viewtopic.php?f=14&t=4482 (https://www.sportsmobileforum.com/viewtopic.php?f=14&t=4482)
Also when you brake...
|
Forum: Projects, Modifications and Known Issues
04-01-2013, 09:44 PM
|
Replies: 3,418
Views: 733,011
Re: What did you do to your SMB today?
Moreover with less than half-tank, simply stopping may cause the bottom to kick out pulling down the whole drain.
But you should really start a thread, it's a good mod, curtain and all, and...
|
Forum: Projects, Modifications and Known Issues
03-26-2013, 10:43 AM
|
Replies: 3,418
Views: 733,011
Re: What did you do to your SMB today?
You're doing it wrong.
Today I plugged it back in after disconnecting 50' shore power line to plow... someday I'll do some electrical work and get rid of the extension nightmare, that is if it...
|
Forum: Projects, Modifications and Known Issues
03-07-2013, 08:06 PM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
12-21-2012, 10:06 PM
|
Replies: 3,418
Views: 733,011
Re: What did you do to your SMB today?
That was going to be my guess too. Mine was like that- luckily they're easier to adjust than house outlets. The two offset screws are on wings and likely your hole is squared just fine- you can...
|
Forum: Projects, Modifications and Known Issues
11-11-2012, 10:47 AM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
04-28-2012, 06:19 PM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
03-24-2012, 04:59 PM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
03-18-2012, 05:52 PM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
12-31-2011, 10:57 PM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
10-03-2011, 11:56 PM
|
Replies: 3,418
Views: 733,011
|
Forum: Projects, Modifications and Known Issues
09-22-2011, 09:47 PM
|
Replies: 3,418
Views: 733,011
Re: What did you do to your SMB today?
Installed Monroe shocks so I can make Ouray tomorrow for the Imogene run Saturday. Thanks to Bilstein for not understanding the difference between "In Stock" and "we'll build 'em when we bother".
...
|
Forum: Projects, Modifications and Known Issues
09-18-2011, 10:33 PM
|
Replies: 3,418
Views: 733,011
Re: What did you do to your SMB today?
Test fit my cables and chains:
[thumb:26uw3cdr]17280[/thumb:26uw3cdr]
viewtopic.php?p=68525#p68525 (https://www.sportsmobileforum.com/viewtopic.php?p=68525#p68525)
|
Forum: Projects, Modifications and Known Issues
08-28-2011, 02:32 PM
|
Replies: 3,418
Views: 733,011
|