shortbox97

Got the worst 2 sections of drip rail patched in today. I'll have to seam seal the underside of these sections in addition to filling...

drivers side drip rail was a mess. only one small spot needs to be welded on the passenger side. all the rust cut/ground out: plan...

floor welding is done. patch right behind the cab: front corner of passenger side wheel well: looking from front to rear...

thanks, it's been a pain in the balls but it's nice to learn a new skill

got the new floor piece trimmed up and the van floor prepped. weld thru primer on both rear of the patch panel was a little squishy...

Yo, new van owner. Or rather, new owner of an old van 94 e350 club wagon, previous city gov van in alabama. 5.8l / e4od with 155k miles...

You can see the oem supports under the floor, i'm working on removing those with a die grinder and a burr bit so I can have a flat sheet...

I was planning to just weld in flat sheetmetal but ultimately decided it would be easier to weld in a section of oem floor from another...

I have all the plastic panels removed as well as the headliner. all those are going back in once the floor is done and headliner is...

and pics of the crust I have to fix. Fairly certain there's a leak from either the drip rail or one of the side windows. The oem vinyl...

New owner to a 94 e350 and have some rust repair to do before going on a road trip 2.5 months from now. Here is the van. Ive always...

or rather, a new owner of a well-used club wagon. decided to join after seeing so many good threads and good advice posted bought the...