Forum: Electrical and Electronics
05-21-2022, 05:20 PM
|
Replies: 4
Views: 1,026
Thanks Greg (Scalf77)!
I’m going to remove...
Thanks Greg (Scalf77)!
I’m going to remove the existing frame-mounted auxiliary battery and it’s associated components (the relay). I wouldn’t want to connect downstream of that 40A relay, because...
|
Forum: Electrical and Electronics
11-27-2021, 09:04 PM
|
Replies: 4
Views: 1,026
Hey carringb, thanks for your response, I...
Hey carringb, thanks for your response, I appreciate your engagement and willingness to help other forum members.
I’m restarting this project and I’m at wit’s end on the electrical.
Per your...
|
Forum: Hobbyist Vendor Products
09-18-2020, 04:35 PM
|
Replies: 668
Views: 177,024
|
Forum: Electrical and Electronics
09-18-2020, 04:19 PM
|
Replies: 4
Views: 1,026
|
Forum: 4x4
08-17-2018, 10:36 AM
|
Replies: 11
Views: 2,243
|
Forum: 4x4
08-17-2018, 10:20 AM
|
Replies: 11
Views: 2,243
|
Forum: 4x4
08-17-2018, 10:14 AM
|
Replies: 11
Views: 2,243
|
Forum: 4x4
08-17-2018, 10:08 AM
|
Replies: 11
Views: 2,243
My main concern is that the axle that was...
My main concern is that the axle that was installed is either not heavy-duty enough or came off some other type of Ford Econoline (like an E-150, or a passenger van, or something). I'm also wondering...
|
Forum: 4x4
08-17-2018, 10:05 AM
|
Replies: 11
Views: 2,243
HELP! Rear Axle Questions - '01 Quigley
Hello all -
I've searched and searched to no avail (and have contacted Agile - Quigley next) but figured I should reach out to the experts on this forum.
Here's the backstory:
I ordered an...
|
Forum: Homemade SMB - Ground Up Builds
02-11-2018, 11:35 AM
|
Replies: 47
Views: 24,106
Blowby, I finished the installation of the B4...
Blowby, I finished the installation of the B4 into my van yesterday. I say finished, but I still have to clean up some wiring runs, build a protective shield/box, etc... but it's working and blasting...
|
Forum: Homemade SMB - Ground Up Builds
11-09-2017, 06:07 PM
|
Replies: 47
Views: 24,106
|
Forum: Homemade SMB - Ground Up Builds
11-09-2017, 06:05 PM
|
Replies: 47
Views: 24,106
Noted on the "full blast before shut down"...
Noted on the "full blast before shut down" procedure - I'm liable to end up posting "heater instructions" next to the controller just so all van occupants are aware :cool:
And I like the concept...
|
Forum: Member Classifieds
11-09-2017, 10:02 AM
|
Replies: 9
Views: 3,952
|
Forum: Homemade SMB - Ground Up Builds
11-09-2017, 09:56 AM
|
Replies: 47
Views: 24,106
Steel, good sir.
Scotty, I hear you - I...
Steel, good sir.
Scotty, I hear you - I almost went the same route in terms of running a diesel in a gasser but ultimately decided to "go for it" on the petrol espar. I will report back as soon as...
|
Forum: Homemade SMB - Ground Up Builds
11-08-2017, 11:13 PM
|
Replies: 47
Views: 24,106
|
Forum: Homemade SMB - Ground Up Builds
11-08-2017, 11:00 PM
|
Replies: 47
Views: 24,106
Thanks for the photo! I agree with you and Ray...
Thanks for the photo! I agree with you and Ray (1der) regarding the length of the pickup tube.. given how little fuel it uses, it seems prudent to put it within an inch or so of bottom of tank.
...
|
Forum: Welcome Mat
11-02-2017, 05:31 PM
|
Replies: 11
Views: 2,925
|
Forum: Homemade SMB - Ground Up Builds
11-02-2017, 05:26 PM
|
Replies: 47
Views: 24,106
I had seen this installation and found it...
I had seen this installation and found it interesting. I thought I had read in the installation manual that the fuel pick-up for the Espar should be vertical.. but I could be wrong. I would also be...
|
Forum: Homemade SMB - Ground Up Builds
11-02-2017, 05:24 PM
|
Replies: 47
Views: 24,106
Very cool thanks for all the info folks, much...
Very cool thanks for all the info folks, much appreciated!! Soon after posting I started googling images of the sending unit and sure enough, it looked perfect to drill.
Noted on replacing the...
|
Forum: Homemade SMB - Ground Up Builds
11-02-2017, 01:08 AM
|
Replies: 47
Views: 24,106
|
Forum: Member Classifieds
05-06-2017, 07:57 AM
|
Replies: 9
Views: 3,093
|
Forum: Welcome Mat
11-25-2016, 02:45 PM
|
Replies: 11
Views: 2,925
Thanks, acrtictraveller, that puts my mind at...
Thanks, acrtictraveller, that puts my mind at ease. I jumped at the opportunity to own an SMB without doing an extensive amount of research on the engine (which I would have preferred) so I...
|
Forum: Welcome Mat
11-20-2016, 09:59 PM
|
Replies: 11
Views: 2,925
Hesitation for the V10 is due to the fuel...
Hesitation for the V10 is due to the fuel consumption (CA fuel prices) and my understanding is that the diesel is a more reliable rig overall. But I am thankful for the extra power when going up...
|
Forum: Welcome Mat
11-20-2016, 01:34 PM
|
Replies: 11
Views: 2,925
Introducing Apache Cheef - 2001 V10 4x4 Hi-Top
Hi all!
I've been lurking the forums for a while, quite a while, and am proud to say I'm finally a member of the family! After reading this forum and seeing these babies on the road I've come to...
|
Forum: Hobbyist Vendor Products
08-14-2016, 05:35 PM
|
Replies: 11
Views: 3,646
|