Forum: Member Classifieds
05-26-2023, 09:41 AM
|
Replies: 3
Views: 856
2006 F350 axles and control arms. home made...
2006 F350 axles and control arms. home made control arm brackets.
Np271 transfer case manual shift
pretty basic set up, would like to have gone DOM and heim joints for the control arms. if it...
|
Forum: Member Classifieds
05-25-2023, 11:20 AM
|
Replies: 3
Views: 856
2001 EB e350 4x4 6speed hightop
I'm Looking to sell my beloved van.
I have done all the conversions myself and have run out of motivation/ time to finish.
the motor and body have 200xxxKM the speedo has not worked since...
|
Forum: Projects, Modifications and Known Issues
03-14-2023, 07:26 AM
|
Replies: 14
Views: 4,604
|
Forum: Projects, Modifications and Known Issues
12-24-2022, 10:08 AM
|
Replies: 14
Views: 4,604
|
Forum: Projects, Modifications and Known Issues
12-23-2022, 09:24 AM
|
Replies: 14
Views: 4,604
|
Forum: Projects, Modifications and Known Issues
12-23-2022, 09:22 AM
|
Replies: 14
Views: 4,604
rear axle is from a 2006 F350
Trans sensor...
rear axle is from a 2006 F350
Trans sensor wiring is un changed but do have to jump pins so the computer thinks its in park.
Front drive shaft from the manual is needed. Rear needs to be...
|
Forum: Homemade SMB - Ground Up Builds
12-21-2022, 09:55 PM
|
Replies: 5
Views: 3,251
Iam also from BC and did a hightop conversion...
Iam also from BC and did a hightop conversion about 2 years ago. I did not change any insurance or anything. I'm not sure what would happen if you got a vehicle inspection.
My top came off a Wheel...
|
Forum: Projects, Modifications and Known Issues
12-21-2022, 09:02 PM
|
Replies: 14
Views: 4,604
ZF6 swap 2001 E350
I'll start this off letting you know I am horrible at taking photos while doing projects.
I have only a few photos of the build, however felt like posting so that anyone with the same idea can...
|
Forum: 4x4
01-27-2021, 07:46 AM
|
Replies: 31
Views: 16,817
I battled Extreme DW on a home build coil...
I battled Extreme DW on a home build coil Conversion. I tried everything turned out to be the belting on a set of used tires I bought. I put new ones on and haven't had DW in 2 years.
I can also...
|
Forum: Appliances and Interior
01-15-2021, 07:05 AM
|
Replies: 15
Views: 4,709
|
Forum: Appliances and Interior
01-11-2021, 02:31 PM
|
Replies: 15
Views: 4,709
Econoline Suspended Bed Frame??
I'm Looking into the idea of having an aluminum bed frame that lowers down from the ceiling. This way when not in use as a camper I still have plenty of room for hauling dirt bikes and its not in the...
|
Forum: Show & Tell
12-17-2020, 06:59 AM
|
Replies: 6
Views: 1,798
|
Forum: 4x4
12-15-2020, 07:53 AM
|
Replies: 11
Views: 2,171
2006 F-350 front and rear axles. that way you...
2006 F-350 front and rear axles. that way you dont need a spacer for the rear. Just have to move the Rear spring perches over roughly 2" also the stock control arms work on the front with a drop...
|
Forum: Show & Tell
12-14-2020, 05:14 PM
|
Replies: 6
Views: 1,798
Thanks!:b5:
Right now the interior is...
Thanks!:b5:
Right now the interior is gutted. I will be spray foaming and doing a very basic camper conversion, as it is my dirt bike hauler. So the back needs to be usable. I'm a little stuck on...
|
Forum: Show & Tell
12-14-2020, 04:16 PM
|
Replies: 6
Views: 1,798
2001 eb e-350
I bought this van from a driving school about 2 years ago with 120xxx kms since then I have 4x4 swapped and put a high top on. I have been all over in it and has been perfect to me.
Still lots of...
|
Forum: Member Classifieds
01-21-2020, 09:59 AM
|
Replies: 6
Views: 1,076
Looking for hightop installation.
I'm looking for someone to install a high top in my van. I have the top, doors, and all the trim. Planned on doing it myself, however due to injury and up coming surgery I wont be able to do this for...
|
Forum: Appliances and Interior
09-25-2019, 10:25 AM
|
Replies: 10
Views: 6,635
|
Forum: Welcome Mat
09-23-2019, 05:27 PM
|
Replies: 3
Views: 657
Damn! that's my luck.
I'm hoping to do the...
Damn! that's my luck.
I'm hoping to do the roof this weekend but that would be awesome to check your high top out before hand. do you have the tall doors? I am missing one extension piece for the...
|
Forum: Welcome Mat
09-23-2019, 03:42 PM
|
Replies: 3
Views: 657
Newbie West coast Barn build
Hey there, MY names Clayton, I'm from Maple Ridge BC. I have a 2001 E350 7.3l that I 4x4 swapped myself. and named C-69 (local busses are C-45)
slowly building it up. next for the project is a high...
|