For sale is Road Armor Rear bumper. Swapped this off my 2002 E350 for an Aluminess. It's in great condition with some surface rust that can just be wire brushed off, and some paint chips. The bumper includes the hitch, and I also have the frame mounting blocks.
Asking price is $800 or make a reasonable offer. Local pickup only i'm located in Salt Lake City, UT.
Just a couple words of advice for the eventual new owner.
I got one of these a few years back from the forum and the arms were seized and the original green handled toggle clamps where a bit rough. I ordered new replacement toggle clamps from McMaster Carr that were an exact bolt on replacement only difference was that the new ones had red handles instead of green which I liked better anyway. Part number on McMaster Carr was: 5093A17
I also drilled and tapped a hole in each of the swing arms to install zerk grease fittings to allow the greasing of the swing arms from time to time as Road Armor didn't seem to allow for greasing the pivot. Once I did that I was able to free up the arms and now everything works great!
Just my .02 as this is now only the 2nd one of these bumpers I have seen posted on here! Hope this is helpful.
__________________
New Van: 2000 Ford E350 SMB RB42
Old Van(sold): 1995 Dodge B3500 SMB RB33
@ Ben10281: Thanks for the great tip and the McMaster-Carr part number- I pick up the bumper here in a week or so and will likely make the mods that you suggest. Much appreciated!
Ford Zilla
Linear Mode
