Hi Scalf77... I'm new to this forum and I hope I am contacting you appropriately.
I was reading your awsome description of how to install the Kisae DMT-1250 DC to DC charger. I bought one of these and have not 'cracked the seal' on the unit because the documentation I have read leads me to believe that cannot use the CUSTOM PROGRAM mode and Temperature Compensation simultaneously.
That is, I can set the Absorb and Float values to match the battery manufacturer's instructions, but I can't use Temperature Compensation either with or without the sensor. So you can have the voltages you want or you can correct for temperature on the default voltages, but you can't do both.


In your post you wrote
" I will choose Program or Custom Settings, and program the Bulk/Absorption to 14.3 and the Float to 13.3"


Laster in the post you state that you will be using the Sensor for Temperature Compensation ( to these custom settings). This is what I assumed I could do until I read the manual.



My question for you is 'Were you able to use a Custom settings and Temperature Compensation( either by sensor or key) at the same time?


Lee L