Quote:
Originally Posted by boostmd
Are you a Quigley + Agile RIP setup? Any other mods to get the 35's to fit?
|
Please keep in mind what one person has done to make 35’s fit on a agile rip quigley, might not work for you. I’ve seen countless places on how people needed to trim here and there to get them to work on their van. There’s no this is how you do it or you need these pieces and your good to go. There’s a lot of variance in the vans over the years. I was able to bolt on 35’s to a stock quigley without any mods needed. The tire would come in contact with the lip on the bumper on a full compression with wheels at the lock, but it was so minor that I never did anything about until I got the rip kit and 9” wide wheels, even then, all I had to trim was a small pie cut on the bumper. Zero trimming to fenders or anything else.
Since I posted, adding current setup.
atx cornice wheels: 17x9/-12et/8x170/4.53 bs/3600 max load
general grabber atx tires: 315/70r17
original agile rip kit (moog c880 springs, sway spacer, v1 valving), currently v4.