Anyone try using 3m VHB tape to install a maxxair deluxe?

[REF]

I did much the same with VHB tape and Dicor self leveling lap sealant to mount a 2nd solar panel on the roof of our travel trailer with aluminum angle iron, held up great, no issues. Just hope you never need to pull it off.

[GVan]

VHB tape is used to hold glass units weighing over 300 lbs in aluminum framing on buildings. Just make sure to follow install instructions.

[CamperDude]

It's all finished! looks great. Glad I didn't have to drill 14 holes in the roof.

I'll post back if it ever flys off but i doubt it.

I used this tape if anyone else is interested
https://www.amazon.com/dp/B01BU7038A

[SMB123]

Nice job! I would have expected the sealant to level more but should be great. The aerodynamics of the solar should deflect a lot of wind pressure too. Looks like a very permanent fix.

[Dearranged]

I redid the rooftop on s stepvan and replaced one of the three a/c with the same fan. Used silicon sealer as the glue and sat it in there. Agree on not wanting all the holes in the roof. I have noticed that the silicone will release s slick surface after a few years so I’ll have to keep an eye on it.