Passenger seat airbag sensor wiring

[Steve Hunt]

I have the passenger seat on a swivel and have swivelled it many times but i suppose something didn't lay just right and the 2 wires/pins pulled out of the yellow Ford connector. Now i have a airbag symbol on the dash.

The wires did not separate from the pins so I'm hoping i can just push the pins back in the connector. Does it matter which pin goes in which hole?? One wire is yellow w/red stripe and one is Green w/black stripe. Which wire goes nearest to the locking mechanism on the yellow Ford connector under the passenger seat? Thanks

[posplayr]

It is probably polarized so just check the other side seat.

[Steve Hunt]

Originally Posted by posplayr

It is probably polarized so just check the other side seat.

I just checked the drivers side and unfortunately it has 4 wires none of which are colored like the passenger side…doh

[boywonder]

[Steve Hunt]

YES!!! Buy that man a beer. It didn’t go down without a fight as it was difficult to get one of the pins in the proper depth but finally it went and the light on the dash is out…trip to Ford adverted, thank god!