Forum: Sprinter Chassis
01-13-2024, 11:26 AM
|
Replies: 9
Views: 1,328
|
Forum: Electrical and Electronics
01-13-2024, 10:55 AM
|
Replies: 14
Views: 1,119
You can buy led strip lights by the roll. Just...
You can buy led strip lights by the roll. Just cut to the length you want. Solder on some wires for power and ground. No need to terminate the other end. You can link another strip by soldering wires...
|
Forum: Electrical and Electronics
09-07-2023, 08:28 AM
|
Replies: 19
Views: 1,848
|
Forum: Projects, Modifications and Known Issues
08-17-2023, 06:39 PM
|
Replies: 23
Views: 2,238
|
Forum: Meetups and Trip Reports
06-28-2023, 10:47 PM
|
Replies: 74
Views: 12,601
|
Forum: Member Classifieds
05-29-2023, 02:00 PM
|
Replies: 2
Views: 586
|
Forum: Member Classifieds
03-22-2023, 11:28 AM
|
Replies: 4
Views: 657
|
Forum: Member Classifieds
03-19-2023, 05:16 PM
|
Replies: 1
Views: 473
Front Bushwacker flares
For Ford E series
I got these from another forum member and had them on my van for years. Time to pass them on to someone else who might want them.
They have been trimmed at the front to...
|
Forum: General Sportsmobile
03-02-2023, 12:34 PM
|
Replies: 8
Views: 1,073
Look at the sliders under the seat bottom. Not...
Look at the sliders under the seat bottom. Not the actual base. If the sliders are in the same location you may be able to switch bases.
Id also be interested in taking a look if you do sell. I...
|
Forum: Member Classifieds
02-09-2023, 09:12 PM
|
Replies: 4
Views: 840
|
Forum: Homemade SMB - Ground Up Builds
01-31-2023, 05:18 PM
|
Replies: 31
Views: 2,907
|
Forum: Homemade SMB - Ground Up Builds
01-31-2023, 04:54 PM
|
Replies: 31
Views: 2,907
The rear seat option doesn’t have to be...
The rear seat option doesn’t have to be permanent.
Mine is basically a board that fills in the isle for the cushions to rest on. Just put it in place when you need to sit.
I think it will still...
|
Forum: Homemade SMB - Ground Up Builds
01-31-2023, 09:13 AM
|
Replies: 31
Views: 2,907
I built mine in a similar fashion.
I’m...
I built mine in a similar fashion.
I’m assuming you have an older Ford or Chevy based on the comment about the curvature of the van. And yes, it will be an issue if so. I’m 6’1” and the way mine...
|
Forum: Electrical and Electronics
11-19-2022, 12:28 AM
|
Replies: 4
Views: 531
It will be to add power to outside functions....
It will be to add power to outside functions. Reverse lights, work lights, source for paddle board air pump!
Don’t want to run several circuits through the floor with added wire length and don’t...
|
Forum: Electrical and Electronics
11-18-2022, 08:30 PM
|
Replies: 4
Views: 531
Underbody power distribution
I’m looking to add a power distribution block/fuse panel under my van.
Supplied by the under body leisure battery bank.
It will get mounted out of direct water/mud, unlikely to see deep water...
|
Forum: Member Classifieds
11-14-2022, 08:25 PM
|
Replies: 0
Views: 710
FS: Ford e350 rear leaf springs
These were taken out of my van because they are too stiff for the weight. They were stock springs. And then had leafs added to stiffen and raise it about 1-2 inches.
They were originally 3/1 spring...
|
Forum: General Sportsmobile
10-20-2022, 04:39 PM
|
Replies: 5
Views: 803
|
Forum: 4x4
09-27-2022, 05:57 PM
|
Replies: 18
Views: 2,183
|
Forum: Member Classifieds
08-19-2022, 01:55 PM
|
Replies: 13
Views: 1,985
|
Forum: General Sportsmobile
08-06-2022, 01:11 PM
|
Replies: 4
Views: 828
|
Forum: General Sportsmobile
07-14-2022, 02:10 PM
|
Replies: 50
Views: 13,409
|
Forum: Show & Tell
04-07-2022, 09:58 PM
|
Replies: 894
Views: 289,666
|
Forum: Member Classifieds
03-07-2022, 10:10 AM
|
Replies: 23
Views: 4,336
|
Forum: Engines and Drivetrain
02-27-2022, 08:32 PM
|
Replies: 20
Views: 5,689
|
Forum: Electrical and Electronics
02-24-2022, 08:28 PM
|
Replies: 11
Views: 1,418
|