Reply
 
Thread Tools Display Modes
 
Old 01-20-2015, 02:11 PM   #1
Junior Member
 
Join Date: Oct 2010
Location: Alabama 35633
Posts: 14
Scangauge II X-Gauge setups

I have programed several X-Gauges on my Scangauge II as listed below. May be of interest to others.

FICM Vehicle Power (Volts) (Should be 12 Volts)
TXD: 07E02209CE
RXF: 0462450906CE
RXD: 3010
MTH: 006401000000
NAM: FVP

FICM Logic Power (Volts) (Should be 12 volts)
TXD: 07E02209CF
RXF: 0462450906CF
RXD: 3010
MTH: 006401000000
NAM: FLP

FICM Main Power (Volts) (Should be 47-48)
TXD: 07E02209D0
RXF: 0462450906D0
RXD: 3010
MTH: 006401000000
NAM: FMP

VGT Duty Cycle (%)
TXD: 07E022096D
RXF: 04620509066D
RXD: 3010
MTH: 00647FFF0000
NAM: VGT

Transmission Fluid Temp
TXD: 07E1221674
RXF: 046205160674
RXD: 3010
MTH: 000100080000
NAME: TFT

Engine Oil Temp
TXD: 07E0221310
RXF: 046245130610
RXD: 3010
MTH: 00090005F060
NAME: EOT
__________________

__________________
2007 Sportsmobile FRB-50 4X4 Diesel, Aluminess front & rear, Espar D4 Airtronic, XL storage, leather, Kenwood GPS, electric Penthouse, Solar panels
2003 GMC Sierra 2500HD 4X4 Duramax Diesel
2006 Jeep Wrangler Rubicon LJ
tyonb is offline   Reply With Quote
Old 01-22-2015, 06:39 PM   #2
Senior Member
 
Pschitt's Avatar
 
Join Date: Nov 2012
Location: Switzerland
Posts: 1,009
Garage
Re: Scangauge II X-Gauge setups

Great, thanks for sharing.
__________________

__________________
Travelling in VivaLaVida (custom 2010 6.0 Ford E-350 Extended with U-Joint 4WD conversion)
Pschitt is offline   Reply With Quote
Old 01-24-2015, 10:40 AM   #3
Senior Member
 
Join Date: Jul 2011
Location: Flagstaff, AZ
Posts: 1,755
Re: Scangauge II X-Gauge setups

Here's a few more with recommended levels or settings to watch for. Shamelessly re-posted from this thread. http://www.powerstroke.org/forum/6-0l-e ... -pids.html

KO=KEY ON LI=LOW IDLE HI=HIGH IDLE OR=OPERATING RANGE (High idle for these tests is set at 2500 RPMs, and Engine at operating temps)

FICM Vehicle Power (Volts) (Should be 12 Volts, should not drop below 10.25 for more than 60 seconds, or 9.0 for 4 seconds. TSB 09-24-03)
?TXD: 07E02209CE
?RXF: 0462450906CE
?RXD: 3010
?MTH: 006401000000
?NAM: FVP

KO=12.0 LI=14.0 HI=14.0 OR=10.5-15.5
?

FICM Logic Power (Volts) (Should be 12 volts)
?TXD: 07E02209CF
?RXF: 0462450906CF
?RXD: 3010
?MTH: 006401000000
?NAM: FLP

KO=12.0 LI=13.5 HI=13.5 OR=10.5-15.5
?
FICM Main Power (Volts) (Should be 47-48) Your FMP should never dip below 45. If it does, your FICM is toast and needs repaired or replaced.
?TXD: 07E02209D0
?RXF: 0462450906D0
?RXD: 3010
?MTH: 006401000000
?NAM: FMP

KO=47 LI=47.5 HI=47.5 OR=40-52 (yes, that is what it says from Ford)

VGT Duty Cycle (%)
?TXD: 07E022096D
?RXF: 04620509066D
?RXD: 3010
?MTH: 00647FFF0000
?NAM: VGT

KO=0 LI=73 HI=43 OR=0-100 %
?
Engine Oil Temp
?TXD: 07E0221310
?RXF: 046245130610
?RXD: 3010
?MTH: 00090005F05F (00090005FFD8 alternate MTH found)
?NAM: EOT

Engine hot KO=190 LI=190 HI=190 OR= -40 - 302 *F
?
Trans. Fluid Temp
?TXD: 07E1221674
?RXF: 046205160674
?RXD: 3010
?MTH: 000100080000
?NAM: TFT

Horsepower
?TXD: 00
?RXF: 400080000000
?RXD: 0000
?MTH: 000A00240000
?NAM: HPR

?
Inj. Control Press. (ICP / HPOP)
?TXD: 07E0221446
?RXF: 046205140646
?RXD: 3010
?MTH: 003900640000
?NAM: ICP

KO=0 LI=625.5 HI=1400-1450 OR=0-4045


ICP Voltage (Volts)
?TXD: 07E02216AD
?RXF: 0462451606AD
?RXD: 3010
?MTH: 004827100000
?NAM: ICV

KO=0.2 LI=1.0 HI=1.8 OR=.15-4.7 Volts


IPR Duty Cycle
?TXD: 07E0221434
?RXF: 046285140634
?RXD: 3008
?MTH: 0DCA03E8000A
?NAM: IPR %

KO=14.84 LI=24 HI=40.60 OR=0-50 %
?
Throttle Position 1 (Volts)
?TXD: 07E0220917
?RXF: 046245090617
?RXD: 3010
?MTH: 006404000000
?NAM: TP1
?Note: Voltage of the ETC Throttle Position Sensor number 1

KO=4.0 LI=4.0 HI=3.4 OR=0.7 - 4.2 VOLT Accelerator Pedal Track 1
?
Throttle Position 2 (Volts)
?TXD: 07E0220918
?RXF: 046245090618
?RXD: 3010
MTH: 0064040000000
?NAM: TP2
?Note: Voltage of the ETC Throttle Position Sensor number 2


KO=1.4 LI=1.4 HI=1.9 OR=1.4 - 4.1 VOLT Accelerator Pedal Track 2
----------------
Throttle Position Desired (Degrees)
?TXD: 07E022091A
?RXF: 04624509061A
?RXD: 3010
?MTH: 0064020000000
?NAM: TPD
?Note: ETC Commanded Throttle Angle, in degrees.
?
Throttle Position Actual (Degrees)
?TXD: 07E022093C
?RXF: 04624509063C
?RXD: 3010
?MTH: 006402000000
?NAM: TPA
?Note: The measured throttle angle from the throttle sensor inputs.
?
EGR Duty Cycle (Percent)
?TXD: 07E022166E
?RXF: 04620516066E
?RXD: 3010
?MTH: 006440000000
?NAM: EGR

KO=0 LI=0-15 HI=32 OR=0-44 %
?
EGR Throttle Position Control Signal
?TXD: 07E022096C
?RXF: 04620509066C
?RXD: 3010
?MTH: 00647FFF0000
?NAM: ETP
?
EGR Valve Position (mm)
?TXD: 07E022096A
?RXF: 04620509066A
?RXD: 3010
?MTH: 000100010000
?NAM: EVP
?Note: EGR Valve Position in hundredths of a millimeter, where 0 mm indicates a closed EGR valve position.
?
EGR Valve Position Desired (%)
?TXD: 07E02209D2
?RXF: 0462050906D2
?RXD: 3010
?MTH: 00647FFF0000
?NAM: EVD

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

EGR Valve Position Measured (%)
?TXD: 07E02209FE
?RXF: 0462050906FE
?RXD: 3010
?MTH: 00647FFF0000
?NAM: EVM
Note: MEASURED EGR Valve Position, in %, where a low value indicates a closed EGR valve (0 EGR flow), and a high value indicates an open EGR valve.

KO=0 LI=0 HI=9.72 OR=0 - 14 PERCENT
??
EGR Valve Position (Volts 0-5)
?TXD: 07E022167E
?RXF: 04620516067E
?RXD: 3010
?MTH: 000133330000
?NAM: EGV

KO=0.8 LI=0.8 -1.0 HI=1.3 OR=0.6 - 3.5 VOLT
?
Camshaft & Crankshaft Sync (1 = in sync, 0 = not in sync)
?TXD: 07E02209CD
?RXF: 0462050906CD
?RXD: 3000 (3001 alternate)
?MTH: 000100010000
?NAM: SYC

KO=0 LI=1 HI=1 OR 0-1 (NO/YES)
?
Intake Air Temperature 2 (Fahrenheit)
?TXD: 07E02216A8
?RXF: 0462051606A8
?RXD: 3010
?MTH: 000100010000
?NAM: IA2

Engine HOT KO=113 LI=113 HI=113 OR= -40-250 *F




Barometric Pressure
?TXD: 07E0221127
?RXF: 046285110627
?RXD: 3008
?MTH: 003100500000
?NAM: BMP

Here is another BAR if the above one is not working for you. The one below works for me.
Barometric Pressure (PSI)
TXD: 07E0221442
RXF: 046285140642
RXD: 3010
MTH: 001D00500000
NAM: BAR

KO=96.5 (14) LI=96.5 (14) HI=96.5 (14) OR=50 - 120 (7.3 - 17.4) kPa (PSI) ?

Exhaust Back Pressure
?TXD: 07E0221445
?RXF: 046285140645
?RXD: 3010
?MTH: 001D00500000
?NAM: EBP

KO=103 (15) LI=110 (16) HI=110 (16) OR=55 - 607 (8 -88) kPA (PSI)
?
Fuel Level
?TXD: 007E02216C1
?RXF: 0462451606C1
?RXD: 3010
?MTH: 000101480000
?NAM: FL
?
Volume Fuel Desired
?TXD: 07E0221411
?RXF: 046245140611
?RXD: 3010
?MTH: 006400100000
?NAM: VFD
?
Mass Fuel Desired (Milligrams Per Stroke)
?TXD: 07E0221412
?RXF: 046205140612
?RXD: 3010
?MTH: 000100100000
?NAM: MFD

KO=0 LI=7.5 HI=10.7 OR=0-100


Engine Run Time (Minutes)
?TXD: 07DF011F
?RXF: 0441051F
?RXD: 2810
?MTH: 0001003C0000
?NAM: ERT

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

Fan Speed Sensor (RPM)
?TXD: 07E022099F
?RXF: 04620509069F
?RXD: 3010
?MTH: 000100040000
?NAM: FSS

KO=0 LI=533 HI=488 OR=0-4000
__________________
2005 E350 RB 6.0 PSD for extended fun
1989 Landcruiser FJ62 for local fun
2011 VW TDI Golf for hwy fun
JoeH is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Sportsmobile SIP or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 09:06 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
×